Sigma EF-610 User Manual download pdf (Page 22)

B. USING THE SIGNAL OF THE FLASH THAT IS ATTACHED TO THE

CAMERA AS THE TRIGGER

For Wireless Flash, two or more EF-610 DG SUPER SO-ADI flash units are necessary. EF-530 DG

SUPER SO-ADI can be used only with off-camera mode. Depending on the flash unit model of

off-camera flash, it is necessary to change the control mode of the controller. Please see the below

chart. (EF-610 DG SUPER SO-ADI can be used for the controller).

Flashgun model can be

used for off-camera flash

EF-610 DG SUPER SO-ADI

EF-530 DG SUPER SO-ADI

EF-610 DG SUPER SO-ADI

Control Mode

Camera model can be

used with off-camera flash

α700, α900 α900

Ratio-Flash Control setting

It is possible to control up to 3

groups;Controller, Off-Camera

Flash 1 and Off-Camera Flash 2.

It is possible to set flash-ratio of

each group from 5 levels or

without falsh.

It is possible to control 2

groups;Controller and Off-Camera

Flash.

Controller : It is possible to set the

ratio of off-camera flash to 1:2 or

2:1.

Flash Mode

TTL Auto flash, High Speed Sync

Flash (TTL, M), Manual flash

TTL Auto flash, High Speed Sync

Flash (TTL)

B-1.In the case of using only off-camera flash

Camera and Controller Setting

1. Set the camera to the wireless flash mode.

◆ Since the settings vary depending on the camera model, please refer to the instruction manual for

your camera.

2. Set the camera’s exposure mode to P,A,S or M.

3. Attach the flashgun to the camera body.

4. The flashgun’s LCD panel will be switched to the controller

setting display automatically. (If the LCD panel will not be

switched automatically, press the

button until the

controller setting display appears.)

5. The control mode display will blink when the

button is

pressed.

6. Set the control mode to

by pressing the or button.

7. Channel information will blink when the

button is pressed.

8. Set the channel number (C1 - C4) by pressing the

button.

9. The ratio-flash control display will blink when the

button is pressed.

10. Set the ratio-flash control mode to [

] by pressing the or button.

11. Press the

button again, the display will stop blinking.

Off-Camera Flash Setting

12. Press the button until the off-camera flash display appears.

13. Set the off-camera flash number to 1 by pressing the

button.

14. Press the

button to set the flash mode to TTL.

15. Channel information will blink when the

button is pressed.

16. Press

button to choose the same channel number as

set on the controller.

17. Press the

button, the indicator stops blinking.

18. Place the off-camera flash at the desired position.

19. Check that both flashes are fully charged.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 127 128

Comments to this Manuals

No comments

Sigma EF-610 User Manual Page 22

Comments to this Manuals

Related products and manuals for Camera flashes Sigma EF-610